A published cost guide read for this page puts a standard tank water heater swap at roughly $874 to $1,765, with a national average near $1,293. The same guide has a tankless unit at about $2,500. Fuel, venting and access decide whether your quote lands inside or outside that band. The service itself is described on the main page for water heater repair and replacement.
Is it cheaper to have a big-box store install a water heater?
Sometimes the sticker price is lower, but a store install is a package: unit, standard labor, haul-away, and often a list of exclusions. Anything past the standard job, such as a permit, a new shutoff valve, a larger vent or a strapping kit, gets added. Compare the total in writing, not the unit price.
Ask three things of any store or plumber quote: does it include the permit, does it include removal of the old tank, and does it include a gas flex connector, vent work and earthquake strapping. Those items separate a fair quote from a low one that grows on the day.
Some stores hire a local plumbing business to do the installation. Whoever turns up is the one whose license and insurance count, so ask who it is.
What is the usual price of replacing a water heater?
According to the guide we read, a typical total runs $874 to $1,765, and the national average is about $1,293. A storage tank averages near $1,000, against about $2,500 for tankless. Split by fuel, electric ran $600 to $3,500 and gas $700 to $2,700, with materials and labor included.
Those ranges are wide for a reason. Forty gallons is the most common tank size, but the guide lists 30 to 80 gallons as typical, and bigger tanks cost more. High-efficiency models sit higher ($1,500 to $3,000 in the same source), and hybrid heat pump units run $1,200 to $3,500.
Use a table to sort your own quote:
| Piece | Guide range |
|---|---|
| Whole replacement, typical | $874 to $1,765 |
| Labor, standard swap | $150 to $450 |
| Removal of old unit | $100 to $500 |
| Permit | $25 to $300 |
| Expansion tank | $40 to $350 |
| Power vent instead of direct vent | extra $300 to $600 |
| Gas line addition | $275 to $825 |
Source: Bob Vila water heater cost guide, 2021, updated 2024, national figures. Local quotes can differ, and a plumber prices the real job after a visit.
How much would repairing the heater cost instead?
Parts are much cheaper than a new tank, but no sourced national figure turned up for us to quote, so rely on quotes. Repair makes sense when an element, thermostat, thermocouple or relief valve has failed on a non-leaking heater under roughly ten years old. Water pooling under the tank means replacement.
A rough rule: take the repair quote and add a likely second repair within a year. If that sum approaches half the price of a new unit, buying new is usually smarter, particularly for a tank nearing the end of its life. Age is discussed on our page about the usual replacement interval for a heater.
Specific parts have their own pages: the thermocouple, electric elements and emergency repairs. Thermopile and burner problems on gas units, and thermostat failures on electric ones, are diagnosed on site. A plumber should price the part and the visit separately.
A furnace and a water heater are separate systems. Some companies bundle them, but the quote for each should be listed on its own so you can compare.
What do plumbers bill to swap a water heater?
Plumbers are listed in the same guide at $45 to $200 an hour, and standard replacement labor at $150 to $450. The totals differ because the unit, the venting, the permit and removal are billed on top. Emergency calls outside business hours often cost more, so ask whether a premium applies before you agree.
Converting from a tank to tankless is far larger: the guide puts that labor as high as $2,500 because gas lines, vents and sometimes electrical service change. What a tankless install costs lists those extras, and tank versus tankless compares the two.
What raises the price on a Murrieta job?
Three factors come up most. First, California requires earthquake bracing on water heaters, so strapping belongs in a proper install. Second, a swap generally calls for a permit and an inspection, which the City of Murrieta Building and Safety Division or the county (for unincorporated areas) handles. Third, an old gas or electric line may need updating.
Location in the house matters too: a garage unit is simple, an attic or closet unit adds cost through access and drain pans. Third-party estimates rate Murrieta tap water moderately hard to hard, so scale buildup shortens a tank's life, and many people also ask about checking the anode rod, or about a softener. See the expansion tank page for another extra that comes up.
To get started, request a quote. We send it to nearby plumbing companies, which pay this site a fee for introductions, and the company you hear back from prices and carries out the job. Other services are on the home page.
Common questions
What size water heater will a family need?
The cost guide lists 30 to 80 gallons as typical, and 40 gallons is the usual size. Larger households and long showers push people up to 50 gallons. The plumber chooses a size using the first-hour rating and the number of people drawing hot water together. See the 50-gallon price page.
Will the price change if the heater is in an attic or tight closet?
Yes. Access adds labor, and an attic unit needs a drain pan and a drain line, so budget for it. A garage unit on a slab is the simplest install. Tell the plumber where the heater sits, and send a photo of the label and the area when you can.
Does a replacement heater really need a permit?
California generally requires a permit each time a water heater is replaced, with an inspection after. For the City of Murrieta, call its Building and Safety Division at 951-461-6062, or use the office covering your city or county. The plumber normally pulls it. A quote with no permit line is worth questioning.
Can I save money by buying the unit myself?
You might save on the sticker price, but a plumber may not warranty the labor on a unit bought elsewhere, and a wrong model may need venting changes. Ask first. Bring the model number, fuel type and size to the quote so the match is checked.
Last changed