Jump to content

Guide ยท Murrieta

Plumber for a leaking toilet in Murrieta

A toilet leak hides in one of five places. Find which, shut the supply and decide whether it is a tightening job or a repair for a plumber.

Side view of a toilet with five numbered leak points, from the supply valve to a cracked bowl.

Dry the bathroom floor, put paper towels around the toilet and watch. Where the paper goes wet first tells you the source. Close the little wall valve behind the bowl so the supply stops while you look, and use the general toilet repair plumber page if you want the wider picture.

How do I find which part of the toilet is leaking?

Most leaks come from five places: the valve and supply line at the wall, the tank bolts, the seal between tank and bowl, the wax ring at the floor, and a crack in the porcelain. Water that shows only following a flush suggests the bowl base or the tank. Water present all the time points to the supply line or the valve.

A quick sorting guide, by where the water shows up:

Where you see water Probable cause Who fixes it
Wall valve or flexible line Loose nut, worn washer, split line You, often
Under the tank, dripping from bolts Worn bolt washers You, often
Between tank and bowl Failed gasket You or a plumber
Around the base, after flushing Loose closet bolts or a bad wax ring A plumber, usually
Seeping from a hairline Cracked bowl or tank Replace the toilet

If the tank sweats on warm days and drips from the outside, it may only be condensation, which the towel test will separate from a real leak.

Can I fix a leaking toilet base myself?

Sometimes. If the closet bolts are loose, snugging them a little can stop a weep, but over-tightening cracks the porcelain. If water keeps showing after that, the wax ring has likely worn out, so the toilet has to be lifted off the floor to replace it. A careful owner can take on that job, though it is heavy and messy.

Toilet base over a closet flange, with a wax ring seal, closet bolts and the subfloor below.

What the job involves: shut off and drain the toilet, disconnect the supply, unbolt, lift the toilet straight up, clean the old wax, set a new ring or seal, press the toilet down evenly, bolt it and caulk if your local practice says so. The toilet can weigh a lot, so lift with help.

Check the floor before you put it back. Spongy flooring near the flange means water has soaked in for a while, and the subfloor or flange may need repair.

Would a new toilet be better than repairs?

Replace the toilet if the porcelain is cracked, it has needed repeated repairs, or flushing is weak despite fixes. Replacement cost depends on the model and any floor or flange repair, and we leave out any figure we have not verified. See replacing a toilet for what shapes the quote.

Look at the flush as well. If an older toilet draws a lot of water on each flush, a newer WaterSense-labeled model can reduce use; see the EPA's WaterSense program for the label. The range of models is wide, so choose one that fits the rough-in distance of your bathroom.

At what point is a plumber needed for a leaking toilet?

Phone if the leak is at the base and tightening a bolt did not stop it, the floor feels soft or smells, the flange looks broken, water shows on a ceiling below, or the toilet is cracked. The same visit can also replace an old shutoff valve and supply line.

If you want someone you have used before, ask friends who they hired. Otherwise send the quote request; it goes to one nearby plumbing business, which contacts you, and the businesses that take requests pay us a fee. Tell them which row of the table above matches your leak, and what flushing does to it. A stuck or crumbling wall valve is covered in toilet shutoff valve repair.

How can I tell a silent leak inside the toilet?

Drip food coloring into the tank, wait twenty minutes, and keep from flushing. If the bowl turns colored, the flapper or fill valve is leaking into it. That silent leak can waste water with no puddle at all. EPA figures put a typical home's yearly loss to leaks above 9,300 gallons.

Silent toilet leaks rank high among the causes of an inflated water bill. Look at flapper repair or fill valve replacement, or learn why a toilet keeps running. If your bill has jumped, check what makes a water bill high.

Common questions

What makes a toilet leak only when flushed?

Because pressure rises in the bowl and trap during a flush, a weak base seal or a loose bolt shows then. The wax ring is the usual cause. If it keeps recurring, the toilet may be rocking, which means loose bolts or an uneven floor.

Will a toilet leak ruin the floor?

Yes. A slow leak at the base can soak the subfloor and flooring over time, causing rot, mold or a stained ceiling in the room below. Stop using the toilet if you see water pooling, close the wall valve, and have it fixed early, because wet wood only gets worse.

Is a bathroom leak the landlord's job if I rent?

In most cases a leak in the building's plumbing is for the landlord to arrange, since California rentals must have working plumbing. Tell the landlord promptly, in writing, and keep photos with dates. Do not do repairs your lease does not allow you to do.

What happens to the old toilet?

If a replacement is arranged, ask the plumber whether haul-away of the old toilet is in the quote. Some plumbers include it and others charge for it, so settle it before the visit, along with who supplies the new wax seal, bolts and supply line.

References

Last changed